Answer:
- Power off the mower and ensure it’s fully turned off before starting.
- Put on protective gloves to avoid cuts or injuries.
- Carefully turn the mower over so the blade disk faces upward. Place it on a soft, clean surface to protect both the mower and the surface underneath.
→ Caution: Be mindful of the camera module (located at the front top edge of the mower) or the LiDAR module (on top of the mower)—avoid pressing or scratching these components during handling. - Loosen all blade screws using a manual cross-tip screwdriver.
→ Important: Do not use a power or electric screwdriver—its high speed and torque could cause loss of control, potentially injuring your hands or fingers. - Replace all blades and screws with new, compatible parts.
- Tighten the screws securely—but do not overtighten—so the blades stay firmly in place and won’t come loose during operation.
→ Verify that each blade rotates freely around its mounting point (this is intentional and part of the design).